AIM: To calculate the concrete mix design for M35 grade concrete with fly ash and M50 grade concrete without fly ash.   INTRODUCTION: Concrete mix design is a procedure of selecting the suitable ingredients of concrete and their relative proportions with an objective to prepare concrete of certain minimum strength,…

AIM:  To draw a G + 1 floor residential plan according to the vaastu shastra and the essential structural drawing required to be provided to the site for construction and also by assuming the sizes of the structural elements and to calculate the loads as per IS code. INTRODUCTION OF VAASTU SHASTRA: Vaastu shastra…

AIM: To create the given geometrices and trusses in autocad, using the different coordinate system method and the line and circle drawing tools. Geometrics p-1 and p-2 are drawn  using all coordinate systems, and each of the remaining geometrics are drawn using any one of the coordinate systems.   INTRODUCTION: COORDINATE…

QUESTION 1 : Creating a floor plan, footing detail and isometric view using autocad: C.S OF LOAD BEARING WALL OVER SPREAD FOOTING: AIM: To draw the cross - section of a load bearing wall over spread footing. INTRODUCTION: The desired cross section is created in autocad  using primarily the line and rectangle tools. The…

AIM: DRAFTING OF VARIOUS GEOMETRIES USING CHAMFER, FILLET TOOL IN AUTOCAD. INTRODUCTION: Autocad consists of a number of drawing and modification tools. Among the modification tools are the Chamfer, Fillet, Offset, Object, Snap, Rotate, Copy, Move, Mirror, Trim, Extend, and Join. 1) CHAMFER: A bevel or chamfer is an angled…

QUESTION 1: TO DRAFT THE RESIDENCE LAYOUT USING THE AUTOCAD:   AIM : TO CREATE A RESIDENCE LAYOUT SEATING PLAN, TOILET AND UTILITY ROOM PLAN USING AUTOCAD. INTRODUCTION: Autocad offers various tools to perform different tasks.  The various tools which are used for drafting in this project. These tools include construction…

CREATION OF COLUMN SCHEDULE AND DRAWING TEMPLATE USING AUTOCAD. 1) COLUMN SCHEDULE: AIM : TO CREATE A COLUMN  SCHEDULE WITH THE HELP OF LINES AS SHOWN IN THE FIGURE  ABOVE IN AUTOCAD. PROCEDURE: STEP 1: Type units and select engineering and select precision as 0’-0”.  Type limits in the command tab. Lower limits is 0’0.0”,0’0.0”…