TITLE: Building 3D surface CAD model of BMW-Z4 car. SKETCHES: Following sketches were used to buid the CAD model.                   *The CAD model made has few modifications as per I need.  Front Top Side   Back     SOFTWARE: The model is build and rendered…

Solving 2D Heat Conduction Equation Using an Implicit and Explicit Method. Use iterative solvers such as; Jacobi, Gauss-seidel, and Successive over-relaxation. Comparison of Fastest Steady-State Simulation and Fastest Transient Simulation.   List of Program - 1 ] Steady State Analysis Implicit Scheme i)…

Simulation of a 1D Super-sonic nozzle flow using Macormack Method   Introduction: In this project, we are going to simulate the isentropic flow through a quasi 1D subsonic-supersonic nozzle. We will derive both the conservation and non-conservation forms of the governing equations and solve them using the MacCormack's…

Conjugate Heat Transfer Analysis on a graphics card   Introduction: In this analysis, we are going to perform a conjugate heat transfer simulation on the graphic card and determine the heat transfer coefficient for the fluid-solid interface of the processor. Computer processors are designed to run at high temperatures…

Simulating Cyclone separator with Discrete Phase Modelling   Introduction: In this project, we are going to perform cyclone separator simulation with the Discrete Phase Modelling technique.  In addition to solving transport equations for the continuous phase the solver simulate a discrete second phase in…

Aim: In this challenge, we are going to simulate a gearbox. To simulate the gearbox we will be using a dynamic meshing approach in Ansys Fluent.  Introduction: Dynamics meshing means when the mesh is updated every time step. Dynamic meshing is used when there is boundary motion, such as valves, store separation, ships…

AIM: Thermal Management and HVAC Analysis Inside a Data Center.   Introduction: CRAC:  A computer room air conditioning (CRAC) unit is a device that monitors and maintains the temperature, air distribution and humidity in a network room or data centre. One CRAC setup that has been successful is the process…

AIM: Analyze Trace Heating of a Printed Circuit Board (PCB) in Electronics.   Introduction: Printed circuit boards (PCBs) are the boards that are used as the base in most electronics – both as a physical support piece and as the wiring area for the surface-mounted and socketed components.   There are several…

AIM: Airflow Characterization and Parametric Study Through a Louver/Grille.• Wind tunnel simulation of Hexa-grille to characterize its pressure loss.• Parametric study to calculate the grille loss coefficient as a function of the free area ratio.   Introduction: Energy Losses in Ducts - Two…