Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge
AIM
- Routing the following harness layout in Electrical workbench. Making assumption for harness bundle diameters.
- Usingthe Following connectors as shown in layout diagram.
- Adding protective covering on all branches connected to DT06-2S & DT06-4S connectors. Keeping end extremity at 30mm (from connectors end)
Downloading connector 3D data from www.te.com and converting then in electrical component
- DT06-4S
- DT06-6S
- DT06-2S
- DT06-08SA
DT06-4S
- Defining this as a connector then adding connection connecting point and bundle connecting point
DT06-6S
- Defining this as a connector then adding connection connecting point and bundle connecting point
DT06-2S
- Defining this as a connector then adding connection connecting point and bundle connecting point
DT06-08SA
- Defining this as a connector then adding connection connecting point and bundle connecting point
GUIDE LINE
- Sketching the requiered dimention and using the sketch as the guide line
- Placing the connectors near the guide line
Multi branching
- Creating bundle with branch in diffrent diameter between the connectors
Protective covering
- Adding corrugated tube as per the bundle dia for protecting the bundle