Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge
Q1. Route the following harness layout in Electrical workbench. Make assumption for harness bundle diameters. Use Following connectors as shown in layout diagram.
Add protective covering on all branches connected to DT06-2S & DT06-4S connectors. Keep end extremity at 30mm (from connectors end)
Download connector 3D data from www.te.com
- DT06-4S
- DT06-6S
- DT06-2S
- DT06-08SA
Answer:
- First to download for the required connector for the assembly harness context from given the link
- Then load the connector and define electrical parrt as all the connector
- And create the path for connector where should place in the diagram and also given in the required length were given in the question
- Then connect all connector with wire as our wish and also add protective cover in the wire
- Then extermise were at 30mm given all over connector
- Step 1: Load all the given connector and also define electrical
- Step 2: Create the path for the connector as per given in question
- Step 3: Then place the connector as per the given question
- Step 4: And connect the connector with wire using the COT tube
- Step 5: Then add prodective cover in cot tube and also keep end extermise at 30mm from the connector end
- Files:
File were uploaded below and named as 'week 4 challenge.zip' and images also uploaded in the same file