Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge

AIM:- Route the following harness layout in Electrical workbench. Make assumption for harness bundle diameters. Use Following connectors as shown in layout diagram.

Add protective covering on all branches connected to DT06-2S & DT06-4S connectors. Keep end extremity at 30mm (from connectors end)

Connector used:-

• DT06-4S
• DT06-6S
• DT06-2S
• DT06-08SA

FINAL WIRING HARNESS ROUTING:-

CONCLUSION :- The Wiring harness Assembly has been successfully created, considering the design rules as mentioned in the given data.