Fender Design

Report On Fender Drip area calculation challenge:

As per the Master section given for fender drip area challenge, made offset away from the Fender appearance surface. Appearance area must be visible outside and it gives good appearance for body. Every operation must be carried out with in the limitation.

Criteria for Drip area given in Master section, As per the drawing Drip are must be lied between ‘less than or equal to 300mm’ distance from A-Piler region and 150 mm Head light area.

An approximate area considered for ‘A-piler’ and extension created for A-piler installation law extension. 100mm Offset plane created for locating Drip area from A-piler area.

150 mm Datum plane has created from Head light region, an approximate area identified for Headlight region.

Excess area was trimmed with respect to the offset line created. As per the master section, shapes are created and maintained the dimensions.

Three joint area created in drip area. Embosses are created with respect to the projected drawing created on Drip area surface. Embosses are created with respect to the plane of surface to avoid radius of curvature.

Bumper mounting area crated with the help of Law extension. Supporting angle is crated, by using DART for proper reinforcement to Bumper mounting area.

Joint areas are created just like drip area created.

Holes area created in Baffle region to mount mud guard with fender. Reliefs are given due to curving structure of baffle region.

Sill Area is created by Extend command. Joining areas are created just like the same.

Relief is created for front door installation.

A-Piler mounting area is completed by giving joining points, after all these sharp edges and corners are smoothened by giving trim sheet. Sew done to join every single face together.

Thickening is done with a value of 0.75mm as standard.