Objective: To perform steady-state simulations on the mixing tee geometry In a table, compare the following values from the 3 cases.  Cell count Average outlet temperature Number of iterations for convergence Expected results: Velocity and temperature contour plots on the cut planes along and across the pipe.…

Objective: Simulate the flow over a cylinder and explain the phenomenon of Karman vortex street.    PART-I: Simulate the flow with the steady and unsteady case and calculate the Strouhal Number for Re= 100.  PART-II: Calculate the coefficient of drag and lift over a cylinder by setting the…

Objective: To perform a grid independency test on Ahmed Body. Expected Results: 1. Velocity and pressure contours.  2. The drag coefficient plot for a refined case. ( For velocity of 25m/sec, the drag coefficient should be around 0.33). 3. The vector plot clearly showing the wake region.  4. Perform…

Aim: Observing the thermal behaviour of a hot fluid flowing through the exhaust pipe, and obtaining an accurate value of the Heat Transfer Coefficient on the internal solid surface of the exhaust manifold. Introduction: Why and Where CHT is used?? The term CHT is used to describe processes which involve…

Objectives:  To understand the Rayleigh-Taylor instability  To carry out the transient simulation mixing of different density fluid using Multiphase VOF method  To understand the different CFD models based on RT instability  To realize the effects of Mesh size and Atwood Number on RT instability Rayleigh–Taylor…

Aim: To Perform a steady-state conjugate heat transfer analysis on a model of a graphics card. Objective: To perform steady-state conjugate heat transfer analysis of graphic card. To understand the effects of air velocity on heat transfer. To compare coarse and refined mesh results. Introduction:  The conjugate…

Part-1: Aim: To perform and Analyze the simulations on the gearbox sloshing effect and compare the results among all the four cases. Objective: To solve the following Four Cases:                  1. 20% Immersion, Fluid (Engine oil).        …

Aim:- To perform analysis on cyclone separator and calculate the separation efficiency and pressure drop.   Objective:- To write a few words about any four empirical models used to calculate the cyclone separator efficiency.  To perform an analysis on a given cyclone separator model by varying the particle…

Aim: To perform a parametric study on the gate valve simulation by setting the opening from 10% to 70%.  Objective:  Obtain the mass flow rates at the outlet for each design point. Calculate the flow coefficient and flow factor for each opening and plot the graph. Discuss the results of the mass flow rate…

Aim: Perform a combustion simulation on the combustor model and plot the variation of the mass fraction of the different species in the simulation using line probes at different locations of the combustor. Objective: (1). Perform a combustion simulation on the combustor model and plot the variation of the mass fraction…