Aim: To carry out geometry cleanup operation on 3 given models, extract the Mid-surface, generating a 2D mesh and assigning proper thickness using generic property   Objective: To perform geometry cleanup, mid surface extraction and 2D meshing under given quality criteria for the models provided   Workflow: Geometry…

Aim: To create 1D elements to connect two surfaces, perform 3D meshing for the given models and write the procedure for the same Objective of project: To carry out 3D meshing using various methods of converting 2D mesh to 3D under given quality criteria for 2D elements To demonstrate connection of two surfaces through…

  Aim: To run the base simulation of crash beam with and without modification to element properties and comparing the resultant plots of the two case setups   Objective of project: To carry out base and modified element properties simulation To check energy and mass errors and decide whether results are acceptable…

Aim: To run the simulation of ruptured plate using different material & property cards, analyzing & comparing the results obtained in different cases Objectives of project:     1.To carry out ruptured plate simulation with various types of material and failure cards     2.To interpret and compare…

Aim: To run the crash tube simulation using different contact interface definitions & performing meshing operation on the bumper assembly provided Objective: Comparison of results of crash tube simulation for the different cases of contact interfaces Mesh the bumper model provided Workflow(for simulation):     …

Aim: To  carry out frontal crash simulation & study the analysis results of the BIW model of a generic car Objective: Create necessary contact interfaces with recommended parameters Remove penetrations & intersection if any Rigid wall creation Applying Kinematic conditions Check model for good quality Request…

Aim: To carry out side crash simulation & study the analysis results of the BIW model of a generic car. Objective: Create necessary contact interfaces with recommended parameters Remove penetrations & intersections if any Rigid wall creation Applying Kinematic conditions Check model for good quality Request cross…

Aim: Quasi-static roof crush analysis of BIW model of a generic car Objective: Perform transformation operations on the impactor to place it over B pillar Creation of appropriate interfaces & boundary conditions Analyzing elemental energy, equivalent plastic strain, hourglass energy, von mises stress, added nodal mass…