Benchmarking is the process of comparing a product, service, or process with the best practices in the industry. Basically it is done to improve performance, efficiency, and enhance the quality of a product or service. The whole point of bench-marking is to get to know that what are the features and qualities that is already…

Under-body coating is a protective layer applied to the underside of vehicles to protect them from corrosion, rust, and damage caused by road debris. The coating is typically made of materials such as asphalt, rubber, or wax, and it is applied to the undercarriage using a spray or brush, The main aim behind the under-body…

AIM - To Design and assemble the car hood. OBJECTIVES – Design of Hood Inner Panel by following given Master section with emboss creation. Creation of Embosses on Hood Inner Panel for Hinges. Assembly of Hinges with Inner Panel. Creation of Latch Trajectory. Mounting and assembly of Striker with the creation of embossing…

Aim - To calculate section modulus of hood and optimize the design to have improved section modulus.   Section modulus - Section modulus is a geometric property for a given cross-section used in the design of beams or flexural members. Other geometric properties used in design include area for tension and…

OBJECTIVE - To check the given fender wheel arch design as per european standards. FENDER WHEEL ARCH - Wheel Arch is the semi-circular part of the fender positioned above the wheel of the vehicle. The design of the wheel arch of the fender should be such that it must shield wheels and protect both passengers compartment…

FENDER DESIGN AIM - To design a  front fender of a car by following the given master section as per the design considerations of OEM. INTRODUCTION - A fender is the part of a car that protects and frames its wheels and keeps mud from splashing it. Most modern vehicles have fenders on their front wheels.…

OBJECTIVE - The objective of this project is to design car roof with  essential flanges and reinforcements  like ditch area , front roof rail , bow roofs, central roof rail and rear roof rail for the the given styling surface. Perform a curvature study on the roof and perform the calculations for the heat distortion…

BACKDOOR   AIM :- Design of the Outer upper pannel and lower panel, inner panel, and the necessary reinforcements by following the design parameters for the given styling surface. INTRODUCTION :-  The trunk or backdoor of a car is the vehicle's main storage or cargo compartment,…

AIM -To create the solid part body of BASE BRACKET from given Class-A surface.OBJECTIVE -The objective of this challenge is to create BASE BRACKET DESIGN along with solid part body from Class-A surface following OEM design standards in CATIA SURFACE WORKBENCH and PART DESIGN.INPUT CLASS 'A' SURFACE -SOLID PART -DRAFT ANALYSIS:DRAFT…