AIM Create the Base Bracket Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.  Class-A surface given: Tooling Axis:   The tooling…

AIM:Create the Switch Bezel Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.  Take the Thickness of the component to be 2.5 mm…

AIM   To Create the Core and cavity blocks for the switch bezel component. To open cadpat of switch bazel Input To create a tooling axis Switch bazel closed surface Draft analysis: The Draft Analysis command enables you to detect if the part you drafted will be easily removed. This type of analysis is performed…

 Aim: Create the Coin Holder Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.  The Thickness of the component to be 2.5 mm…

AIM Create the Bumper Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.  Take the Thickness of the component to be 3 mm  …

  Attachment Feature Creation (Ribs & Screw Boss) AIM: To Create the Door Handle Component from the given Class-A surface. To Create the tooling axis for the given Class-A Surface meeting the requirements of the draft angle. To Attach B side Features in the component. To perform the Draft analysis on the model. …

AIM Create the Dog House for the Door Trim considering the design rules mentioned in the video. Consider the thickness of the part to be 2.5 mm. Dog house rules Class A surfaces CREATING TOOLING AXIS -                       The Tooling Direction is basically the…

AIM Create the Door Trim Lower Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.  Create the Heat Stakes and the locators considering…

A pillar Design with Master Section Given A surface with pillar curves Tooling axis  create the two lines with the master section, bisecting the line & create the tooling axis.if the tooling axis should be in puling direction to the cor and cavity of the part A surface boundry check no gab or discontinutity found…

QUICK RETURN MOTION MECHANISM: To create a individual drawing for each component as per given diagram   Slotted lever  Base Circular slider Connecting Rod Slider Assembly CV JOINTS Part 1 Part 2 Assembly    

AIM To design and development of vehicle interior door trim using Catia V5 with given class A surface along with Master section. Also create the side attachment features as per design rules. Introduction The door panel is the interface between the interior of the car and inner working of the door. Generally, the door panel…