1. Answer: a) Genarator b) Battery c) Starter d) Ignition coil e)Ammeter f) Foot selector switch g) Breaker h) Fuse i)Current and voltage regulator j)Gas tank unit k)Breaker l)Fuel gauge m)Switches n)Junction block o)Horn p)Parking lamp.   2. Answer: The three elements: i) Generator ii) Breaker…

Answer:   % Read the current values from VI.xls file vi=xlsread('VI.xls','A2:A25'); % Read the voltage values from VI.xls file vv=xlsread('VI.xls','B2:B25');  %intervals xq=(-17.3:0.1:0.9);  %interpolation for values of xq yq=interp1(vi,vv,xq); %plote the vv v/s vi with(o) & interpolation values plot(vv,vi,'o',yq,xq,'-') …

                                            POSITION CONTROL OF SPRING MASS DAMPER SYSTEM   Aim:  To build the position control of mass spring Damper System with the Help of the transfer Function and…

AIM: To create the individual part files and then create a complete assembly of those part files in the assembly workbench. After creating the assembly make use of the drafting tools to create a 2D drawing similar to the one given in the assignment folder. ASSEMBLY WORKBENCH: Select the Start-> Mechanical Design -> Assembly…

AIM:          Create the Base Bracket Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.   CLASS A SURFACE:         Class ‘A’ surfaces are…

AIM:        Create the Switch Bezel Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model. CLASS A SURFACE:         Class ‘A’ surfaces are primarily…

  AIM:           Create the Bumper Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.     CLASS A SURFACE:         Class ‘A’ surfaces are…

  AIM:        Create the Door Drill Handle component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model. And Create the Rib and Screw boss for the Drill Handle…

                                                                                           DOG HOUSE FOR DOOR TRIM AIM:          Create the Dog House for the Door Trim considering the design rules mentioned in the video. Consider the thickness of the part to be 2.5 mm.       CLASS A SURFACE:         Class ‘A’ surfaces…

  AIM:          Create the Door Trim Lower Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.           Create the Heat Stakes and the locators…

  AIM:           Create the A PILLAR through the given Class-A surface with Master Section considering the design rules and perform Draft analysis.   OBJECTIVES: Creation of Tooling axis Creation of Class B and Class C surface from provided Class A surface. Creation of solid part out of surface modeling. Create engineering…

Development of a Door Trim panel   AIM:         To design the car door inner panel with reference to given Class-A surface by using given master section, creating attachment features and performing draft analysis to check the manufacturing feasibility of the component by using software CATIA V5. Objective:         The…