Make a Simulink model of Doorbell using solenoid block with the following details: ANS:-                         * In this Model I have used the following Blocks with the functions:       1. Solenoid:- A solenoid converts electrical…

Implement control logic of a “washing machine” using Stateflow as per given sequence:  If the power supply is available, the system gets activated  If the Water supply is not available, stop the process & indicate through LED Soaking time should be 200s followed by Washing time of 100s. Then rinsing…

AIM:- To Perform the simulink BAJA ATV vehical model by changing the parameter like throttle,break and observed the variations. DISCRIPTION:- The model of BAJA ATV with Continuously variable transmission(CVT).  In This Model I Saw following Points, 1) Components of BAJA ATV 2) Vehical Model 3) Effect of Parameter…

1. For EV_defaults_in file, if cargo mass is 500 kg with all other default conditions, can the vehicle travel for 45 km with FTP drive cycle? Conclude your observations.  ANS:-          ADVISOR (advance vehicle simulator) is designed for rapid analysis of the performance and fuel economy of…

What is the difference between mapped and dynamic model of engine, motor and generator? How can you change model type? ANS:- Powertrain blockset provide two type of model:- Mapped model Dynamic model   1]    Mapped model:- It is quite faster than Dynamic model. its run based on the Data given in the …

1.  Which types of power converter circuits are employed in electric and hybrid electric vehicle?   ANS:-  Power Converter Power converter is converting electrical energy from one form to another such as converting between AC & DC or changing the voltage & frequency. Following power converter…

1. A. Explain a MATLAB demo model named ‘Speed control of a DC motor using BJT H-bridge’.     B. Comment on the armature current shoot-up from the scope results.     C. Refer to the help section of ‘The Four-Quadrant Chopper DC Drive (DC7) block’. Compare it with the H-bridge…

For a defined driving cycle, calculate the energy required for braking. ANS:- In electric vehicle we require acceleration as well as deacceleration,As we require to stop vehicle in stipulated time. we can't allow vehicle to stop for inertia value,for stoping vehicle we have to apply the brake. We require some amount of…

Part A:- 1)Introduction: -  An aircraft is a vehicle that is able to fly by gaining support from the air. It counters the force of gravity by using either static lift or by using the dynamic lift of an airfoil, or in a few cases the downward thrust from jet…

Create a MATLAB model of electric car which uses a battery and a DC motor. Choose suitable blocks from Powertrain block set. Prepare a report about your model including following: Objectives:         1. System level configurations        2. Model parameters      …