Abhishek Ghongade
A civil engineering grad with a curiosity of learning new things and look forward to apply it in the professional life further.
Introduction
6 Projects
Project on Concrete Mix Design for various grades of Concrete
DESIGN OF M35 GRADE OF CONCRETE MIX USING FLYASH Stipulations for Proportion. Grade of concrete: M35 Type of cement: OPC 43 grade confirming to IS8112 Type of Mineral Admixtures: fly ash confirming to IS3812(Part 1) Maximum size of aggregate:20 mm Exposure condition: Severe (for reinforced concrete) Minimum cement content …
22 Feb 2021 12:46 PM IST
Sketch a G+1 residential plan according to Vaastu Shastra and Calculation of Loads as per IS code
Aim: To provide a G+1 residential plan as per Vastu Shastra. Introduction: Vaastu Shastra Vaastu Shastra is the ancient science of architecture and acts as a guideline to design your home in a way that enhances positive energy. Our nature is abundant with energy sources like the sun, wind, moon, water,…
10 Jul 2021 03:43 PM IST
Creation of geometries by Coordinate system methods using AutoCad
Aim: To create the geometries of the P1 form above using different coordinates system methods. Introduction: there are different types of coordinate systems that can be used. Absolute coordinate system. In this system, the absolute location of the point is given as an input. Always the origin(0,0) is the reference…
15 Aug 2021 06:04 AM IST
Creating a Floor plan, Footing detail and Isometric view using AutoCad
AIM: To Create a Cross-section of a load-bearing wall over spread footing using AUTOCAD. INTRODUCTION: Following are the commands which are used to draw the objects in AUTOCAD: Rectangle(REC): It is used to create a rectangle with the desired dimension. Polygon(POL): It is used to create a polygon by giving the no. of…
23 Oct 2021 12:37 PM IST
Drafting of various geometries using Chamfer, Fillet tool in AutoCad
AIM: To Create a Diagram in the decimal unit using AUTOCAD. INTRODUCTION: Following are the commands which are used to draw the objects in AUTOCAD: Rectangle(REC): It is used to create a rectangle with the desired dimension. Polygon(POL): It is used to create a polygon by giving the no. of sides and circumscribed about…
22 Nov 2021 11:28 AM IST
Creating a Residence Layout, Seating plan, Toilet and Utility room plan using AutoCad
AIM: To Create layout plan for the given residence using AUTOCAD. INTRODUCTION: Following are the commands which are used to draw the objects in AUTOCAD: Rectangle(REC): It is used to create a rectangle with the desired dimension. Polygon(POL): It is used to create a polygon by giving the no. of sides and circumscribed…
27 Dec 2021 03:26 AM IST
1 Course Certificates
3 Workshop Certificates
Academic Qualification
B.E
Matoshri College Of Engineering & Research Centre, Eklhare, Nashik
10 Aug 2010 - 30 Jun 2016
12th
Jawahar Navodaya Vidyalaya
01 Apr 2009 - 19 May 2010
10th
Jawahar Navodaya Vidyalaya
01 Apr 2007 - 27 May 2008
Here are the courses that I have enrolled
Similar Profiles
Ladder of success cannot be climbed with hands in pocket.
The Future in Motion
Give more than what you get you will get more than what you gave
Avid learner