Wiring harness routing & packaging Rules Week 3 Challenge

AIM

Q1. Download following cad data & define it as Electrical support using Electrical Part design Workbench. Define all the necessary properties.

Q2. Download following Back shell cad data & define it as Electrical back shell using Electrical Part design Workbench. Define all the necessary properties.

Q3. Create Following Corrugated tubes & Add them in Catalogue under “Slit COT” family.

Q1

STEPS

1. Get the Clip 3D part
2. Define the Geometry parameters
3. Defined part as Support
4. Define Entry Point & Plane
5. Define Base & Exit plane

Q2

STEPS

1. Get the Back shell 3D part
2. Define the Geometry parameters
3. Defined part as Backshell
4. Backshell Connection Point
5. Define Bundle connection Point

Q3

STEPS

1. Create Covering 3D part
2. Create Catalogue for Coverings
3. Add new part in Catalogue
4. Apply covering on harness bundles from Catalogue