Wiring harness design in CATIA V5 - 3D modeling Week 5 & 6 Challenge

AIM:

Route two electrical harness as per the given layout and interconnect them as a single harness assembly. Check the bundle continui, bundle warning and the provide annotation for the final harness assembly.

CONNECTORS:

Define all the electrical connectors geometrically and electrically so that can be used in the wiring harness.

HARNESS B:

After all the connectors are defined, the workbench was switched to electrical harness assembly where geometrical bundle was activated. All the connectors were routed using the Multi branchable command.

HARNESS A:

After all the connectors are defined, the workbench was switched to electrical harness assembly where geometrical bundle was activated. All the connectors were routed using the Multi branchable command.

HARNESS ASSEMBLY:

CONTINUITY CHECK:

ANNOTATION:

Annotation is used to show the additional notes.