Wiring harness design in CATIA V5 - 3D modeling Week 5 & 6 Challenge

Aim of the project:

• Route two electrical harnesses per the given layout and interconnect them as a single harness assembly
• Check for bundle continuity, and bundle warnings, and then provide annotations for the final harness assembly.

Objective:

The objective of this project is to first route the two Harness A and Harness B as per the given harness layout.

HARNESS A LAYOUT:-

HARNESS B LAYOUT:-

ASSEMBLY HARNESS LAYOUT:-

The electrical connectors are represented by numbers in the above figure.

1. There are 8 different types of connectors at 10 different locations.
2. Bundle continuity has to be checked for the two created harnesses.
3. After the two Harnesses are created, the next objective is to have them interconnected electrically.
4. Check for bundle warnings in Harness A and Harness B.
5. Add annotations to all the connectors in Harness A and Harness B.

The consideration procedure for all connectors are like:- defining electrical component,defining Bundle connection point and defining conncetor conncetion point etc.

Create a catalogue for various diameter corrugated tube used as covering tube in Harness assembly.

All Images are given below:-

Image(1):-

Image(2):-

Image(3):-

Image(4):-

Image(5):-

Image(6):-

Image(7):-

Image(8):-

Image(9):-

Image(10):-

Image(11):-

Image(12):-

Image(13):-

Image(14):-

Image(15):-

Image(16):-