Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge

 Q1. Route the following harness layout in the Electrical workbench. Make an assumption for harness bundle diameters. Use the following connectors as shown in the layout diagram.

Add protective covering on all branches connected to DT06-2S & DT06-4S connectors. Keep end extremity at 30mm (from connectors end)

 

Download connector 3D data from www.te.com

1. DT06-4S
2. DT06-6S
3. DT06-2S
4. DT06-08SA
   
   
   
   
   
   
   
   CONNECTORS LAYOUT 
   
   STEPS :
   
   DOWNLOAD THE FOLLOWING CONNECTORS
   CREATE REQUIRED GEOMETRICAL PARAMETERS
   DEFINE PART AS CONNECTOR
   DEFINE BUNDLE CONNECTION POINT
   DEFINE CONNECTOR CONNECTION POINT
   
   
   
   
   
   
   
   CREATE A SKETCH FOR REFERENCE AND ARRANGE THE FOLLOWING CONNECTORS BY THE FOLLOWING LAYOUTS
   
   
   
   
   
   CRATE MULTI-BRANCHING TO THE CONNECTORS
   
   
   CREATE PROECTECITVE COVERIG 
   
   
   CHECK AS PER LAYOUT:
   
   
   
   RESULT: ROUTING OF THE FOLLOWING HARNESS LAYOUT USING CONNECTOR IS DONE.