Wiring harness design in CATIA V5 - 3D modeling Week 2 Challlenge

Week 11 - Project - A pillar Design with Master Section OBJECTIVE:- Create the A-pillar Design with Master Section Perform the Draft analysis on the model. Create the feature with reference from the master section provided   ASSUMPTION:- Component material A.B.S "Acrylonitrile butadiene styrene" The thickness…

Week 10 - Challenge 3 - Door Trim Lower with Engineering Features OBJECTIVE:- Create the Door Trim Lower Plastic component through the given Class-A surface. perform the Draft analysis on the model. Create the Heat Stakes and the locators considering the design rules. ASSUMPTION:- Component material A.B.S "Acrylonitrile…

Week 10 - Challenge 2- Attachment Feature Creation (Dog House) OBJECTIVE:- Create the Dog House for the Door Trim Consider the thickness of the part to be 2.5 mm. ------------------------------------------------------------------------------ Different views of the MODEL ------------------------------------------------------------------------------…

Week 10 - Challenge 1- Attachment Feature Creation (Ribs & Screw Boss) OBJECTIVE:- Create the rib for the Drill Handle considering the design rules mentioned Create the Screw boss for the Drill Handle considering the design rules mentioned  ASSUMPTION:- The thickness of the component is 2.5 mm. Component…

Week 8 - Challenge 4 - Bumper OBJECTIVE:- Create the Bumper Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created to meet the requirements of the draft angle  To perform the Draft analysis on the model. Take the Thickness of the component…

Week 8 - Challenge 3 - Coin Holder Design OBJECTIVE:- Create the Coin Holder Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created to meet the requirements of the draft angle Perform the Draft analysis on the model.  Take the Thickness…

Week 8 - Challenge 2 - Switch Bezel Design OBJECTIVE:- Create the Switch Bezel Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model. Take the…

Week 8 - Challenge 1 - Base Bracket Design OBJECTIVE:- Create the Base Bracket Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model. …

PROJECT REPORT:- Wiring harness design in CATIA V5 - 3D modeling Week 5 & 6 Challenge. Q1. Route the following harness layout in the Electrical workbench. Make assumptions for harness bundle diameters. Use DT connectors. After completion of routing do the followings, Check the bundle Continuity. Add snap of result…

  Project On wiring harness design in CATIA V5 - 3D modeling   Q1. Route the following harness layout in the Electrical workbench. Make assumptions for harness bundle diameters. Use the Following connectors as shown in the layout diagram. Add protective covering on all branches connected to DT06-2S & DT06-4S…

Report on wiring harness routing & packaging Rules   1.) Download the following clip cad data & define it as Electrical support using Electrical Part design Workbench. Define all the necessary properties.               Hellarmann Tyton –…

Download connectors & Connector clip cad data from the given link & define it as Electrical Connector using Electrical Part design Workbench. Define all the necessary properties to Connectors & clips   1.) Deutsch DT06 – 08SA ( https://www.te.com/usa-en/product-DT06-08SA.html)   2.) Tyco…