Week 9 - Project - A pillar Design with Master Section

DOOR TRIM PLASTIC PART :   PART : CAVITY MOLD :   CORE MOLD :   2 SLIDERS :      The two sliders used for solve the under cuts.     SECTI0N VIEW :

LENS :   HOUSING : REFLECTOR : ASSY :   ASSY DRAWING : PART DRAWING :

  3D MODEL CUT SECTION

 Create one assembly drawing considering all factors

Define tooling direction The Tooling Direction is basically the direction that the mold pulls apart. The mold is built in two separate pieces, basically. You have a Cavity side and you have the Core side. The Core pulls apart from the Cavity and that's the Dyeline or the Tooling Direction.  …

Door Trim panel:   .

 DRAWING 1: .   DRAWING 2:  

 Door Trim Lower with Engineering Features:  

 Ribs & Screw Boss: RIB ROOT THICKNESS: SCREW BOOS SECTION: DRAFT ANALYSIS:

Core & Cavity Design: PARTING SURFCE: CAVITY SURFACE:     CORE SURFACE: VIEWS:

Bumper:

Coin Holder Design:     DRAFT ANALYSIS:

SWITCH BEZEL:     DRAFT ANALYSIS:  

BASE BRACKET:

Objective:                To Develop the Car Back Door by Using given Styling Surface Method by Automotive sheet metal design. Tool Used:- Nx12 Introduction:                 Design of back door is also called as the Tail gate. A car back door…

                                                                                           …

  OBJECTIVE:          To calculate the wheel arc for given Fender model, by means of the European standards regulations OK or NOT.                                          INTRODUCTION:…

                                                                                           …

                                      SECTION MODULUS CALCULATION AND OPTIMIZATION OBJECTIVE:              To calculate the section modulus for the previeously designed hood and optimized hood.To…

                                                                                                                                                  DESIGN OF HOOD ABSTRACT:              The hood (American English) or bonnet (Commonwealth English) is the hinged cover over the engine of motor vehicles. Hoods can open to allow…

                                                                                           …

                                                                         UNDERBODY COATING   DEFINATION:        …

                                                                                       BENCHMARKING…

                                                                                           …

                                                  MODELLING OF AMERICAN CHOPPER BY USING SOLIDWORKS   OBJECTIVE          To create a 3D model of the American…