Week 8 - Challenge 4 - Coin Holder Design

Aim: To create the tooling axis for the given Class-A surface of the Coin Holder and create a solid part along with Class-B and Class-C surface.

Procedure: The input model for the draft analysis is the class-A surface given by the class-A designers as shown below:

Fig. 1: Class-A Surface of the Coin Holder

Considering the shape of the given component, the tooling axis is made in the Z direction at the center of the base.

Put a point at the center of the base of the Class-A surface, and draw a line through the point in the Z-direction. Name this line as the Tooling Axis.

This tooling axis and the Coin Holder surface need to be accessed multiple times and hence, need to be published. Go to Tools>Publication. These will be published in the feature tree.

Next step is to perform the draft analysis of the part with reference to the Tooling Axis. Go to Insert>Analysis>Feature Draft Analysis. Make sure that the View Mode Customization is set to the Material Mode as shown below:

Fig. 2: View Mode Customization

The draft analysis of the Class-A surface w.r.t. the tooling axis is shown below:

Fig. 3: Draft Analysis of the Class-A Surface

The green coloured faces are given a draft of certain amount and can be cleared using the tooling axis. The faces coloured in blue colour do not have a draft w.r.t. the tooling axis and hence, these surfaces cannot be cleared using the tooling axis.

Also, we are not allowed to change the shape of the given Class-A surface, hence we will proceed building the Class-B and Class-C surface on this part only.

A similar approach was followed to perform the draft analysis of the closed surface, and the results are shown below:

Fig. 4: Draft Analysis of the Closed Surface

Creating the Class-B Surface:

The Class-B surface was divided into multiple parts, the base, the side wall, the top wall, and the flanges. The surfaces were extracted individually and, commands such as Untrim, Offset and Extrapolate were used to make these surfaces. These surfaces were then trimmed together to get the final Class-B surface. Finally, the edge fillets were applied in the appropriate positions. The final Class-B surface is shown below:

Fig. 5: Class-B Surface

Creating the Class-C surface:

To create the Class-C surface, use boundary command on the Class-A surface and use the Sweep command to make a surface perpendicular to the outer faces of the Class-A surface. The Class-C surface is shown below:

Fig. 6: Class-C Surface

The orientation of the Coin Holder is shown below:

Fig. 7: Front View

Fig. 8: Top View

Fig. 9: Right View

Fig. 10: Isometric View

The feature tree of the Coin Holder is shown below:

Conclusion: The draft analysis of the given Class-A surface was completed successfully and a closed surface was built out of the given Class-A surface.