Week 8 - Challenge 3 - Coin Holder Design
COIN HOLDER DESIGN
AIM
To create the coin holder component through the given class A surface.
Objectives
- To create the class B and class C surface.
- To create the tooling axis.
- To create the plastic coin holder component.
- To perform the draft analysis on the class A surface and the final plastic compoenent.
Creation of tooling axis
In the given class A surface the base of the component no have draft angle , its a plat surface .
The base surface is extracted from the given class A surface .
Center point is created on the surface.
From that point one perpendicular line is developed from that point as a reference. That line is declared as the tooling direction.
Draft analysis on class A surface
Front view
Side view
Top view
Isometric view
Draft analysis on the plastic component
Front view
Side view
Top view
Isometric view
Coclusion
The plastic coin holder component is created from the given class A surface . The tooling axix and draft analysis were performed on both the class A and plastic component.