Week 7 Challenge - Assembly Workbench

BASE BRACKET DESIGN AIM: Design base bracket component from the given class-A surface. METHODOLOGY: STEP I: TOOLING AXIS In this step we are creating a tooling axis from the given class-A surface using the intersect method. In this method we created two lines, with the help of these two lines we created a bi-secting…

QUICK RETURN MECHANISM   CV JOINT          

DESIGN OF A BACK DOOR/TAIL GATE AIM: The aim of this project is to design a car backdoor with the help of given CLASS A surface. Design essential flanges and reinforcements like sealing flange, hinge reinforcement, gas stay reinforcement, wiper motor reinforcement and latch & striker reinforcement. Perform…

Roof Design Aim:  The aim of this project is to design a car roof with the help of given skin data and master-section. Design essential flanges and reinforcements like ditch area , front roof rail ,bow roofs, central roof rail and rear roof rail with the help of given master section. Perform a curvature study on the…

1. Benchmark with presently available cars in the market for the given case In this case study, I'm trying to suggest a big car for Mr. D.S. Pughazhyendhii between 8 to 10 lakhs (on road) as per his requirments. First I need to have a clear concept about benchmarking and then I'm going to prepare a detailed report…

Fender Design   Aim: To design a front fender using the given skin data and master section. Fender: Fender is the American English term for the part of an atomobile, motorcycle or other vehicle body that frames a wheel well (the fender underside). Its primary purpose is to prevent sand, mud, rocks,…

Wheel Arch Challenge   Aim:  Calculate the Wheel Arch gap at required points and check whether the car passes the European standard.   Objective:  Study different wheel arch gap standards. Measure the wheel arch gap at specified points.   Wheel Arch:  The wheel arch is…

Section Modulus calculation and optimization   Objective: To find the section modulus of the hood and optimisation to improve the overall section modulus. Section modules (S): Section modulus is the first moment of area about the axis of bending for a beam cross-section. The strength of the beam sections depends mainly…

Project: Automotive Hood design   Introduction: A car hood also referred to as a bonnet in some other countries is the hinged cover that rests over the engine of a front-engine vehicle.   Objective: Design the hood inner panel and outer panel with the help of given hood skin data, master section…

Write a one-pager about Under-Body Coating and its purpose, its types in detail, and its pros and cons. First we have to understand what is underbody coating.   Underbody Coating: Underbody coating is a thick cladding (typically made of rubber) that is placed uniformly to the car’s underside.…

                            Title of the Project: Designing and Photo Realistic Rendering of Sunseeker Predator Yacht. Objective:  Design various types of parts with the help of yacht blueprint using different type of tools…

Title of the Project : Designing and Photo Realistic Rendering of American Chopper.  Objective :  Design various type of parts using different type of tools and commands. Assemble all the parts. Photo Realistic Rendering. Introduction : This report contains an overall view of american chopper. The challenge here is to…