Underbody Coating

FENDER DESIGN AIM: To design a  Front Fender OBJECTIVE: To design a Fender mounting on the given model by using Master sketch by considering the safety and manufacturing feasibility for possible mounting region. ABOUT FENDER  The fender is a sheet metal part of an automobile. It Plays a vital role…

                                                   FENDER WHEEL ARCH CALCULATION: AIM:               To Calculate the Wheel Arch gap at required points and check whether the car passes the European standard. OBJECTIVE: To calculate the clearance (L) at sections of SA-SA, SB-SB, SC-SC, SD-SD and SE-SE as per the European…

  what is section modulus: Section modulus is the measure of the strength of any section with respect to neutral axis. Section modulus is the property of the cross-section that is used while the design of beams.   The section modulus is classified into two types:- 1, Elastic section modulus:- The elastic…

                                                                       HOOD DESIGN  AIM : To design the hood of a car with the given input…

UNDERBODY COATING                    Underbody coating is usually a dense cladding (often based on rubber) applied uniformly to the undercarriage of the automobile. It is normally sprayed or painted on when the car is just out of the dealership and is clean. But even if…

AIM     To make a full solid model from the provided lower door trim A surface and create locator and heat stacks. INTRODUCTION: CATIA:          It means Computer-Aided Three-Dimensional Interactive Application.  It is computer aided designing software.…

AIM Create the Dog House for the Door Trim considering the design rules mentioned in the video. Requirement Screenshots of the completed design in various orientations (Isometric, Front, Side, and Top View) A detailed report explaining the draft analysis and the tooling axis creation should be done.  An explanation…

AIM: To Create the Door Handle Component from the given Class-A surface. To Create the tooling axis for the given Class-A Surface meeting the requirements of the draft angle. To Attach B side Features in the component. To perform the Draft analysis on the model.  TOOLS USED: Boundary Join Multiple extract Bisecting…

CORE AND CAVITY DESIGN AIM:      To Create the Core and cavity blocks for the switch bezel design. TOOLING AXIS:       IT IS THE AXIS IN WHICH THE DIRECTION CORE AND CAVITY OPEN. THIS IS THE VERY IMPORTANT FOR THE PRODUCTION OF PLASTIC COMPONENTS. MOST OF THE DEFECTS WILL BE DONE IMPROPER…

 COIN HOLDER AIM:         To create the coin holder plastic component through the given Class A surface. To begin with, the tooling axis for the given Class-A surface should be created meeting the requirements of the draft angle and at the end perform the draft analysis on the model. Take the thickness…

SWITCH BEZEL Objective : To design switch bezel as per automotive OEM Standard. Create B Class and C Class and tooling axis. Converting close surface into the solid inside part workbench and providing the thickness of 2.5mm. Performing draft analysis to verify the creation of the Tooling axis and C Class surface. Software…

AIM:      To Create the Base Bracket Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the draft angle requirements and performing the draft analysis on the model at the end.  INTRODUCTION The Draft allows the…

   PROJECT REPORT                                                                                   MODELLING…

                                                           THE AMERICAN CHOPPER BIKE MODELLING OBJECTIVES :                  …