To plan a structural layout and to create grids using TSD

Ans:

First Floor Layout Plan

Labelling is done from top to Bottom in vertical Direction while Horizontally, from left to Right Side.

Second Floor Layout Plan, following the same convention as above.

=============================================================================

All columns are of equal configuration, whose properties are described here under as follows:

First Floor Beam Plan

Above screenshot is of First Floor Level, taken under the Review Tab by switching the Material/ Section Properties.

Ground Floor Plan above 50 cm from the Ground Level.

Ground Floor Plan showing various sections to be used.

================================================================================

Second Floor Plan (Section Properties)

Review Status of our Model:

Failing Member has an Interaction Ratio of 1.02 which can be easily corrected but it is intentionally left out because of Irregularity in plan or Due to Odd one out section to be placed near the Stair Case where chances of mistakes increase in the Field work.

Roof Top Portion where three sections are used with properties here as follows:

Rafter Portion: ISMB 350;

Purlin section: ISMB 225;

Sag Rod: Equal Angle Section of 70*70*8 mm with Major Alignment at the Bottom while Minor Alignment at the Centre.

=================================================================================