Project 1

- Purpose

- To make the electrical installation of the given engine and to prepare the plan view.



- Used Software :

Catia V5



Introduction

CATIA® is the world's leading engineering and design software for premium product 3D CAD design. It is used to design, simulate, analyze and manufacture a variety of products in industries such as aerospace, automotive, home appliances and engineering. type of electrical wire. The cable is usually made of thermoplastic material or a thermosetting material that helps protect the cables from the environment. For professionals, it's an easy, low-cost, and easy-to-navigate way to keep ropes tied, protected, and navigated.
Although most wires have an outer sleeve, these sheaths are rarely thick enough to protect the wire from dust, debris, and moisture. The thicker the wire, the greater the risk of damage to the fuse.

The term "cable assembly" is often used interchangeably with the term "cable assembly". But these are two different things. While both are outer sheaths used to protect wires or cables, cable products are made from durable materials designed to provide greater protection in the harshest conditions.
Cable ties and cable ties work differently in the electrical field. Choosing the right product for the desired application is an essential part of your product's success. Ensuring your partners are experienced and knowledgeable will help ensure you are using the right product for your project.


- Design

• Cable routing will facilitate the manufacture, use, removal and maintenance of connecting devices and cables.
• The should not be run through small structures and openings to minimize friction and hold the cable during installation.
• Do not use the cord during assembly or use and do not cut the operator's eyes.
• The rope must be protected from damage resulting from misuse, such as manual handling and temporary support for measuring equipment.
• Adds slack to equipment depending on environment and harness. Make sure the line is properly subtracted from the space around it.
• Do not use cross bolts near bolted connections.
• Damages or punctures the balcony.
• Keep the power cord away from the panel mounting screws.
• Do not use the cable near sharp edges and if this is not possible, provide protection for the cable.
• The maximum distance between the two clips on the flat foot is 200 mm.
• Put clips and clips if the rope needs to be bent in several places.
• Too much metal should be avoided.
• leg length must be higher than 50 mm.
• The minimum distance between clip and the branch point is 25 mm.
• The minimum distance between two broken branches should be 50 mm.

- Input :

-Electrically Defined Components

- Output

- Conclusion :

The Engine wiring Harness project is completed.

"Please look for 'Project 1' after unzipping the folder. "