Creating Conceptual mass in REVIT and Creation of Sinusoidal curve and a Parametric stadium using Dynamo
1) Using Dynamo create a set of sinusoidal points and create a curve and create a surface out of the curve.
ANS:
AIM:
To create a set of sinusoidal points and create a curve and create a surface out of the curve by using dynamo
PROCEDURE:
- Open the revir software
- go to dynamo
- open integer,list,sin math,code block,point,nurbs control point and surface by loft
- connect them in a correct way
2) Create a conceptual layout of floor plan in dynamo . Using the tools available in dynamo link the lines to appropriate model elements in Revit by choosing the wall types and wall parameters. Make use of the sliders to slide through the height of the wall and length of the wall.
ANS:
AIM:
To Create a conceptual layout of floor plan in dynamo . Using the tools available in dynamo link the lines to appropriate model elements in Revit by choosing the wall types and wall parameters. Make use of the sliders to slide through the height of the wall and length of the wall.
PROCEDURE:
- Open revit software
- Open dynamo
- open integer,list,wall type,floor type,levels and wall by curves and height etc...
3) Create an array of model elements in Revit. Use dynamo to vary the properties of model elements by using the slider or code block
ANS:
AIM:
To Create an array of model elements in Revit. Use dynamo to vary the properties of model elements by using the slider or code block
4) Create a conceptual mass in Revit and develop a parametric column by dividing the surfaces and apply the concepts similar to used in parametric walkway modelling. Use triangular bent or square shaped panels to add finish to the parametric column
ANS:
AIM:
To Create a conceptual mass in Revit and develop a parametric column by dividing the surfaces and apply the concepts similar to used in parametric walkway modelling. Use triangular bent or square shaped panels to add finish to the parametric column
PROCEDURE:
- Open revit software
- Open a conceptual model then create a level 2
- by usingmodel line draw a S shape
- Create a plane on the point then create a pentagone in the place
- create a form unsing createform tab and give a triangle pattern
5) Use Dynamo to work on developing a Parametric Stadium. List your parameters and use the visual programming approach to complete the modelling, You can use the concepts discussed in parametric high rise tower in class for reference.
ANS:
AIM:
To Use Dynamo to work on developing a Parametric Stadium. List your parameters and use the visual programming approach to complete the modelling, You can use the concepts discussed in parametric high rise tower in class for reference.
PROCEDURE:
- Open revit software
- then oprn dynamo then define no.of.level and height
- Open integer,rectangle,surfacebyloft etc...
