Benchmarking

BACKDOOR DESIGN  AIM: The aim of the project is to design the body in white parts of the back door of a suv vehicles. Along with designing the reinforcement for hinges, gas stay, latch and wiper motor for the back door. INTRODUCTION: A door is a hinged part which is used for entry and exit of the vehicles. Back doors are…

ROOF DESIGN CHALLENGE OBJECTIVE: To design the automotive roof based on the given styling surface and analyze the prepared model to check the manufacturability. An automobile roof or car top is the portion of an automobile that sits above the passenger compartment, protecting the vehicle occupants from sun, wind, rain,…

SECTION MODULUS CALCULATION AND OPTIMIZATION AIM: To increase the section modulus of a given hood model by necessary changes and then optimizing the hood panel for better section modulus. TOOL USED: NX CAD. INTRODUCTION: Section modulus is a geometric property for a given cross-section used in the design of beams or flexural…

FRONT FENDER OBJECTIVE: The objective of the project is to design a body in white front fender of a car with its mounting using the information provided by the styling team. Master sketch are the information provided by the styling team by considering the safety and manufacturing feasibility for possible mounting region.…

WHEEL ARCH CHALLENGE AIM: To create a fender wheel arch and calculate the wheel arch area using SIEMENS NX CAD and to prove whether the given fender of car will pass the European standards or not. FENDER: A fender is different than a bumper because it's a metal structure that frames the wheel well of your car, instead…

HOOD ASSEMBLY AIM: To understand the design strategy and consideration that goes under designing and developing an automotive hood to achieve maximum safety. Design hood outer panel, inner panel and the necessary reinforcements by following the master section mentioned with the design parameter. Then submit an assembly…

                         UNDER BODY COATING OF CARS UNDER BODY COATING: The primary objective of getting underbody coating done is preventing metal components from corrosion & rust.   It also protects parts like internal body panels, frame rails…

                                                      BENCHMARKING AIM: To prepare a report explaining about and what is benchmarking by comparing a car.     BENCHMARKING: Benchmarking…

YACHT ASSEMBLY REPORT Objective: To design, assembly and render all the individual parts of the yacht model by using the design tool - Ultimate Solidworks. By the usage of sketch tools with fully defined importance of mates in assembly. To render the yacht model by usage of rendering tool in Photo view 360 method. The…

AMERICAN CHOPPER MOTORCYCLE DESIGN REPORT USING SOLIDWORKS_ TAMILARASAN Objective: To design, assembly and render all the individual parts of the American chopper motorcycle model by using the design tool - Ultimate Solidworks. By the usage of sketch tools with fully defined importance of mates in assembly. To render the…