Sidhin George
Design and Development Engineer
Skills Acquired at Skill-Lync :
- CFD
- NUMERICAL-ANALYSIS
- MATLAB
- OPENFOAM
- ANSYS-FLUENT
Introduction
11 Projects
Mixing efficiency
Mixing tee AIM:-To simulate the mixing in a mixing tee to determine the mixing efficiency of cold and hot fluid along the length of pipe. The velocity and temperature is measured to quantify the mixing. Two different cases were solved. 1.Short mixing tee with a hot inlet velocity of 3m/s. Momentum ratio of 2,4. 2.Long…
02 Jun 2020 03:59 PM IST
Steady Vs Unsteady flow over a cylinder
VORTEX SHEDDING FROM CYLINDER Aim:- To perform Steady and unsteady numerical simulation over a cylindrical surface…
16 Jun 2020 08:53 AM IST
Ahmed Body Challenge
AIR FLOW AROUND AHMED BODY AIM:- To perform a CFD analysis on the air flow over a Ahmed body and extracting the important flow parameter like velocity ,pressure and force. Evaluating drag, lift and wake region on Ahmed body. Introduction:- …
28 Jun 2020 08:45 AM IST
Exhaust Port Challenge
CFD analysis of exhaust port Aim:- To…
12 Jul 2020 04:58 PM IST
Rayleigh Taylor Instability Challenge
Rayleigh–Taylor instability Aim:- To simulate a two-dimensional Rayleigh-Taylor instability problem using the classical method of Finite…
31 Jul 2020 03:47 PM IST
Conjugate Heat Transfer Analysis on a graphics card.
Conjugate heat transfer analysis on a graphics card Aim:- To perform a steady state…
11 Aug 2020 04:12 PM IST
Cyclone Separator Challenge
Cyclone separator analysis Aim:- …
20 Oct 2020 05:11 AM IST
Gate Valve Parametric Study
Parametric analysis on gate valve Aim:- To perform a parametric analysis on the gate valve simulation by setting the opening from 10% to 80%. Obtaining the result for mass flow at the outlet for each opening with flow coefficient…
23 Oct 2020 06:34 PM IST
Independent Research Project
CFD simulation of water hammer in a pipeline Aim:- To analysis the maximum pressure surge at the closing end of pipeline due to the effect of water hammer in pipeline by using the CFD simulation. The maximum pressure at the closing end is analysed for two different inlet pressure such the protection…
31 May 2021 03:19 PM IST
Week 3.5 - Deriving 4th order approximation of a 2nd order derivative using Taylor Table method
Aim:- To derive the following 4th order approximations of the second-order derivative of a function `f(x)=e^x×cos(x)` and compare the result with three numerical discretization schemes as stated 1. Central difference 2. Skewed right-sided difference 3. Skewed left-sided difference Writing…
15 Aug 2021 08:57 AM IST
Academic Qualification
B.Tech
Government Engineering College, Wayanad
22 May 2014 - 25 May 2018
12th
St.Sebastian's Higher Secondary School Gothuruth
11 May 2011 - 27 Mar 2013
10th
Swami Vivekanand Modern School
06 Apr 2010 - 23 Mar 2011
Here are the courses that I have enrolled
Similar Profiles
Ladder of success cannot be climbed with hands in pocket.
The Future in Motion
Give more than what you get you will get more than what you gave
Avid learner