FOLLOWED THE BELOW STEPS TO DEFINE COMPONENTS AS ELECTRICAL IN CATIA V5: Downloaded & loaded the 3D file(stp or igs) into CATIA V5. Opened Mechanical Design--> Part Design. Then Defined all the required Geometrical Parameters(Conenctor-Connection Point,Bundle Entry point & Connector-Connection Axis).  …

Objective: To define the Mechanical components electrically and prepare the catalogue for the same. To Prepare the COT tubes and make the catalogue for the same. Steps Involved in Defining the Components Electrically: P-Clip: 1. Download the 3d model of the given clip from open source site.2. Define required geometry parameters…

Objective: To Route the harness layout in Electrical workbench based on the given input.To add protective coverings on all branches connected to DT06-2S & DT06-4S connectors. Keep end extremity at 30mm (from connectors end). Steps Involved: 1.Preparation of Harness Assembly: Create a master product file(Harness Context…

OBJECTIVE: To create a harness layout in Electrical workbench and perform below tasks while doing so: Check the bundle Continuity. Add snap of result in submission Add annotation to all connectors. Make an assumptions for annotations like connect 1 , 2 etc Check for the bundle warning. Add snap. Generate CAT.part of harness…

OBJECTIVE: To flatten the Harness Assembly which was completed in Week 4 Challenge. Below is our objective To flatten the Harness Assembly. To place the flattened view on drawing sheet. To ensure bundles with protective coverings has different visuals on drawing view Fig:1 Harness Assembly of Week#4 Challenge PROCEDURE:…