Aim: To simulate the flow over a cylinder and explain the phenomenon of Karman vortex street Simulate the flow with the steady and unsteady case and calculate the Strouhal Number for Re= 100.  Calculate the coefficient of drag and lift over a cylinder by setting the Reynolds number to 10,100,1000,10000, & 100000. (Run…

AIM: To perform external flow simulation over the Ahmed body and study the wake region. Introduction:  The Ahmed body is a generic car body (a simplified vehicle model). The airflow around the Ahmed body captures the essential flow features around an automobile and was first defined and characterized in the experimental…

Conjugate Heat Transfer Analysis: The term conjugate problem was coined by a group of scientists led by the academician A. V. Luikov in the former who, among others in the 1960s, began to investigate heat transfer as a coupled problem. At that time, many other researchers started to solve simple problems…

AIM: To perform Rayleigh Taylor Instability simulation for the following cases:        1.  Fluid 1: Air, Fluid 2: water             Mesh size(base) : 0.5mm             Refined case of mesh        2. Fluid 1: Air, Fluid…

Aim:  To perform analysis on cyclone separator and calculate the separation efficiency and pressure drop. Objective: To perform an analysis on a given cyclone separator model by varying the particle diameter from 1 μm to 5μm and calculate the separation efficiency in each case. Discuss the…

AIM: To perform a parametric study on the gate valve simulation by setting the opening from 10 % to 80%, and calculate the following quantities: Mass flow rates Flow coefficient Flow factor Introduction: Gate Valve: A gate valve, also known as a sluice valve, is a valve that opens by lifting a barrier…

AIM:  Simulating Conjugate Heat Transfer Analysis on a Graphics card Run the simulation by varying the velocity from 1m/sec to 5m/sec for at least 3 velocities and discuss the results. Find out the maximum temperature and heat transfer coefficient attained by the processor. Prove that the simulation has achieved…

AIM: Simulating Combustion of Natural Gas. Part I: Perform a combustion simulation on the combustor model and plot the variation of the mass fraction of the different species in the simulation using line probes at different locations of the combustor Part II: Add the water content in the fuel from 5% to 30% by mole…