Benchmarking involves a structured comparison between similar products , services or processes on some dimensions of performance. In simple words, its reverse engineering an automobile and improving every aspects of automobile than that of competitors. Automotive benchmarking involves 6 stages- Auto feature- here more…

Underbody caoting   Underbody coating is usually a dense cladding applied uniformly to the undercarriage of the automobile. It is normally sprayed or painted on when the car is just out of the dealership and is clean. The main purpose of undercoating is to check rust especially in the body components like frames rails…

A car hood is also referred a bonet, its is hinged cover that rests over the engine of a front engine vehicle. its purpose is to provide access to engine for repair and maintenance.  it is constructed usually by steel sometimes by aluminium. in the recent trend like for a sport car / performance car it is made up…

section modulus is defined as the ratio of moment of inertia of a section about the neutral axis to the distance of the outmost layer from the neutral axis. it is the direct measure of the strength of the shaft section or beam section. higher the section modulus of a structure, the more resistive it becomes to bendin. …

1. wheel arch : wheel arch is the semi circular part of the fender positioned above the wheel of the vehicle. the design of the wheel arch of a fender should be such that it must shield wheels and protect both passengers, component and pedestrians from projection of water, mud, and stones. for the vehicle to has its use…

fender is also called as quater panel it is the part which is in between the front bumper and the front passenger door, same near rear. it is mainly there to protect the engine part, side colllision of passenger and to prevent the dirt and debris falling on to the inside parts and creating damages to the internal parts,…

Roof : Introduction : An automobile roof of car top is the portion of an automobile that sits above the passanger compartment, protecting the vehicle occupants from sun, wind, rain, and other external elements. the roof must be designed in such a way that it will sustains the impactthe load of accidents. the is assembly…

Aim : To design the back door of the car and make the inner panel or the back door and also design the necessary re-enforcements. software used : student edition Introduction : the trunk or boot of a car is the vehicle's main storage or cargo compartment, often a hatch at the rear of the vehicle. it is alos called a tailgate.…

1 2 3 4 the draft analysis is done for class A surface at 3 degree. tooling direction is got through the center point of circle.  5 the draft analysis is done for B surface at 2.7 degree. it is also green for 3 degree. it is done according to tooling direction. 6 the draft analysis is done om C surface at 2.7 degree.…

1 2 3 4 5 6 7   8 9 10

1 draft analysis is done class B surface. it is done at 3 degeww angle. it is ready to manufacture. tooling direction is created normal perpendicular to the base if this coin holder.  2 draft analysis is done at class A surface. it is done at angle at 3 degree angle. it is ready to use.  3 draft analysis is done…

1 2 3 4 5