Week 8 - Challenge 3 - Coin Holder Design

1

draft analysis is done class B surface. it is done at 3 degeww angle. it is ready to manufacture. tooling direction is created normal perpendicular to the base if this coin holder.

2

draft analysis is done at class A surface. it is done at angle at 3 degree angle. it is ready to use.

3

draft analysis is done at class C surface. it is done at draft angle 3 degree.is it okay to manufacture. it is created using the sweep with the referance surface at 90 degree angle.

4

5

6

7

8

9

10

11

12

13