AIM To create a 3d assembly of internal geneva mechanism using SolidWorks and to conduct motion analysis under motor rpm of 10 and 20 and then post processing it. OBJECTIVE i) To create the 3D model from the 2D part drawing using solidworks. ii) To create the assembly of internal geneva mechanism. iii) To conduct motion…

PROJECT REPORT ON MOTION ANALYSIS OF PLANETARY GEAR   Objective To calculate pitch circle diameter and number of teeth for the planet gear. To make the 3D assembly of planetary gearing which consists of sun gear, four planet gears, ring gear and the carrier. To perform the motion analysis on the given 3D assembly.…

MBD Simulation on a piston assembly 1. Aim Model all the given parts to form the piston assembly followed by its motion analysis in three different conditions to get the linear displacement versus time plot. 2. Objective To carry out the motion study on the piston assembly based on the three different conditions of the…

MBD Simulation on IC Engine Valve System Train   AIM To carry out MBD simulation on the IC engine valve train by following two cases of cam lift. OBJECTIVE To model cam, push rod, rocker arm, valve and valve mount using solidworks. To perform motion study on the assembly with a valve lift of 3.5 mm and 6 mm. To plot…

Aim To simulate a motion of a simple pendulum by solving second order differential equation in Matlab. Theory The figure shows an idealized pendulum with a massless string of length L and a bob of mass m. The open circle indicates the initial position of the bob. When the bob is moved from its rest position, it swings…