Aim : To study the internal flow simulation of a pipe using various inlet Reynolds number Objective : - Run a pipe flow simulation with an inlet Reynolds number of 100,1000 and 10,000. - For each of these cases do the following Place line probes at 95%, 90% and 85% of the pipe length. Compare the normalized velocity profile…

Aim : To study the flow over a cylinder using Solidworks for baseline simulation with varying Reynold Number by a factor of 20%, 40% and 100%. Objective :  Calculate the baseline case Reynolds number. Then increase the Reynolds number by a factor of 20%, 40%, and 100% then run the transient flow simulation. Calculate…

Aim : To perform a flow simulation on a NACA-0017 Airfoil with various angle of attack. Objective : Simulate the flow over an airfoil  Compare the lift and drag force for the angle of attack 2, 4, 6, 8, and 10 degrees TheoryIntroduction What is NACA Airfoils? The National Advisory Committee for Aeronautics (NACA)…

https://skill-lync.com/projects/flow-simulation-using-solidworks-3

Aim : To create an run a flow analysis of a 3D modal Flowbench Objective :  Run a grid dependence test for three different level of initial mesh Run a parametric sweep to show the effect of valve lift on mass flow rate Theory What is an Flowbench? An air flow bench is a device used for testing the internal aerodynamic…

https://skill-lync.com/student-projects/flow-over-an-airfoil-193

Aim : To design a centrifugal pump and analyse the internal flow simulation. Objective :  Design a centrifugal pump. Calculate the Pressure Ratio. Obtain the relationship between Pressure ratio and mass flow rate. Theory/Introduction : What is centrifugal pump? A Centrifugal pump is a mechanical machine…

https://skill-lync.com/projects/centrifugal-pump-design-and-analysis-197