AIM: To set up steady-state simulations to compare the mixing effectiveness for two different versions of mixing tee.             To test k-epsilon and k-omega turbulence models and determine why that model suits our simulation process.             To determine the effect of length on mixing effectiveness.   WORKFLOW:…

AIM: Simulate the flow over a cylinder and explain the phenomenon of Karman vortex street. Part I: Simulate the flow with steady and unsteady case and calculate the Strouhal number for Re=100. Part II:   Calculate the coefficient drag and lift over a cylinder by setting the Reynolds number to 10, 100, 1000, 10000…

Aim of the experiment :-to simulate  externalflow condition over an ahmad body for refined case.To perform a grid independence study. introduction Ahmad body and its performance ahmad body is a simplified form an automobile body that resembles all the essential flow features around an automobile.this body allows us…

Aim:-To simulate a conjugate heat transfer analysis on an inline 4 cylinder manifold. IntroductionThe conjugate heat transfer (cht) analysis,type allows for the simulation of heat transfer between solid and fluid domains by exchanging thermal energy at the interfaces between them.Typical application of the analysis type…

Aim:-To perform rayleigh taylor instability simulation for two different mesh sizes. Theory Rayleigh taylor instability :-it is an instability of an interference between two fluids of different densities which occurs when the lighter fluid pushes the heavier fluid. at wood number :- it is a dimensionless number fluid dynamics…

CHT ANALYSIS ON A GRAPHICS CARD OBJECTIVE In the challenge our objective is to perform a steady state simulation of a conjugate heat transfer in a graphics card.we will be running the simulation for deafault mesh and refined mesh .The air flow over the surface is varied from 1m/s to 5 m/s. from this simulation we want…

AIM :- To perform analysis on cyclone separator and calculate the separation efficiency and pressured drop. INTRODUCTION cyclone separator are separation devices that use the principle of inertia to remove particulate matter from flue gases.cyclone separators is one of many air pollution control devices from known as pre-cleaners…

OBJECTIVE In this challenge our objective is to perform parametric study on the gate valve by setting the opening from 10% to 80%. Thereby we will obtain mass flow rate at the outlet for each opening point. calculate the flow co-efficient and flow factor for each opening and the plot the graph. Discuss the result of the…

PROBLEM STATEMENT 1. Perform the simulation analysis using methane:air fuel mixture and plot the variation of mass fraction of different species using the probes at different location of the combustion chamber. 2.Study the effect of adding water to the methane -air mixture and plot the same and discuss the result  Theory…