Contents of Zip file submitted below (as per instructions provided): Report in PDF format ANSA mesh file for 5 mm Target Length ANSA mesh file for 3 mm Target Length ANSA mesh file for 1 mm Target Length

Contents of the attached Zip file: ANSA File for the volume mesh generated Report

Aim/Objective For the given model, check and solve all geometrical errors on half portion and assign appropriate PIDs. Perform meshing with the given Target length and element Quality criteria. After meshing the half model, Do symmetry to the other side.  Target lengths for the different parts of a model are as follow:…

Aim/Objective  For the given models, check for the geometrical errors and delete surfaces which are unwanted for Surface wrap as shown in the videos. After clearing geometry, merge all 3 models and perform surface wrap.  Target length for Wrap = 3 mm Procedure Step 1: Import the Geometry Model File -> open -> (select the…

Aim/Objective For the given model, check and solve all geometrical errors and Assign appropriate PIDs. Perform meshing with the suitable Target length and element Quality criteria. Procedure Step 1: Geometry Preparation Import the Geometry Model File -> open -> (select the file)   Step 2: Topology clean-up  The…

Aim Set up steady-state simulations to compare the mixing effectiveness when hot inlet temperature is 36C & the Cold inlet is at 19C. Case 1 A: Short mixing tee with a hot inlet velocity of 3m/s. Momentum ratio of 2 Case 1 B: Short mixing tee with a hot inlet velocity of 3m/s. Momentum ratio of 4 Case 2 A: Long mixing…