Rakesh Ramanunni
CAE Engineer
Skills Acquired at Skill-Lync :
Introduction
8 Projects
Head Impact Simulation
PEDESTRIAN HEAD IMPACT USING SIMPLE HEAD OBJECTIVE: To perform the Head Impact Simulation and calculate the HIC value in the LS-PrePost using a rigid…
13 Apr 2022 12:40 PM IST
Challenge 5 - Modelling Spot welds
##Comments by the Grader##Good job on completing the challenge. Your report looks great!! Modelling Of Spotweld OBJECTIVE: To model spotwelds…
30 Sep 2020 09:36 AM IST
Challenge 3 Drop Test of Phone
Drop Test Of Phone Aim: To create an input deck from the given FE model of Phone and Ground Step 1: The file is loded to Ls-Prepost Step…
30 Sep 2020 09:34 AM IST
Week-6 Calculate the Stretch Ratio by comparing the ELFORM (-2,-1,1,2) with Ogden_Material Model.
STRETCH RATIO BY COMPARING VARIOUS ELFORM (-2,-1,1,2) AIM: …
30 Sep 2020 09:34 AM IST
Week - 8 Mass Scaling
Mass Scaling❄ OBJECTIVE: To use mass scaling to reduce the runtime of a model and ensure the stability of mass scaling by altering the values of TSSFAC and DT2MS. PROCEDURE and RESULT: Trial No.1 The .key file provided is opened in Notepad++ and the Timestep Card is ignored and saved and the model…
30 Sep 2020 09:35 AM IST
week-11 Joint creation and Demonstration
Joint creation and Demonstration OBJECTIVE: To demonstrate spherical, revolute, cylindrical, and translational joints between two rigid bodies and two deformable bodies with the help of Ls-Dyna manual (*CONSTRAINED_JOINT keyword). SPHERICAL JOINT PROCEDURE: A spherical…
30 Sep 2020 09:34 AM IST
Bird Strike - Project - 2
Project-2 Bird Strike OBJECTIVE: To simulate a bird strike on an Aero Engine in an organized and disciplined manner with a consistent numbering approach and also to use mass scaling technique to reduce the run time of the model. PROCEDURE: The meshed model of bird strike.key file is…
30 Sep 2020 09:34 AM IST
CRASH BOX SIMULATION
CRASH BOX SIMULATION Objective: To simulate a crash test for a crash box from the given FE model with 1.20mm thickness and comparing the acceleration and stress/strain plot with 1.50mm thickness of the same model. Step 1: The file is loded to Ls-Prepost. Step 2: *Section…
03 Oct 2020 12:03 PM IST
2 Course Certificates
Academic Qualification
B.Tech
Anna University
01 Jun 2012 - 25 Apr 2016
10th
T.E.M.S
10 Feb 2010 - 09 Feb 2011
Here are the courses that I have enrolled
Similar Profiles
Ladder of success cannot be climbed with hands in pocket.
The Future in Motion
Give more than what you get you will get more than what you gave
Avid learner