Wiring harness routing & packaging Rules Week 3 Challenge

AIM

Define the given part as an electrical component.

BODY

For P clamp

Define Support Part

• First open part in part design workbench and create center point on both the side of the clamp, then created the plane on that point ,created the base plane with respect to bottom surface and that plane offset 2mm from surface
• Next switch to electrical part design work bench first define the P Clamp using the Define Support Part command created the entry and exit side of clamp, same is done for other side also.

For Back shell

Back shell connection Point

• First open part in part design workbench and create center point then crate the Axis system on that point where y axis is in connecting direction ,x- axis in locking direction ,z axis in upward direction created on the face where the connector connection is needed.
• Next switch to electrical part design work bench first define using define backshell command
• Next using the Back shell connection point command created the connector connection point. then using bundle connection point command created bundle connection point.

For catalog for corrugated tube.

define protection part

• First open electrical part design workbench and using define protection part command created part by define ID dia, thick and bend radius, after that save the part.
• Next created the catalog document and add family in that selected the conduit then save the catalog file.
• Open the created cot tube then using the sore device command add this part to the catalog then save the file.