Wiring harness routing & packaging Rules Week 3 Challenge

1) downloaded the p clamp and open in part design then created the points & planes for entry & exit for bundles as shown

2) define the support part by switching elctrical part design workbench by selcting respective planes and points for bundle entry & exit

3) Save the part

2)

1) As we download the backshell & open in part design

2) create the points & axis system

3) then switch workbench into electrical part design from part design

4) Then define the part as backshell so publication created in tree

5)after that select the backshell conn. point by respective axes & points as well as bundle conn. points

6) Save the part

3)Corrugated tubes created in catalogue as follows in Slit COT family as shown pic