Wiring harness design in CATIA V5 - 3D modeling Week 7 Challenge

AIM: Route the wiring harness on given car body hatch and prepare the flatten view drawing in CATIA V5. Objective: This project involves the objective to route the wiring harness on given car body hatch and prepare the flatten view drawing in CATIA V5 with all the necessary contraints applicable in Routing. All the…

AIM: Route the wiring harness on given engine and prepare the flatten view drawing in CATIA V5. Objective: This project involves the objective to route the wiring harness on given engine and prepare the flatten view drawing in CATIA V5 with all the necessary contraints applicable in Routing. All the packaging rules…

As per the image attached below wiring harness assembly is created according to the layout mentioned above with all the connectors are electrically defined and with corrugated tubes added to necessary bundles.   After that the CAT product file of harness assembly is exracted to flattening workbench where all the flattening…

  As per the image attached below Harness 1 is created. All the connectors are downloaded and all the necessary electrical parameters of all the connectors are defined and assembled as shown in the image in electrical harness assembly and 3D annotations are added.   As per the image attached below Harness 2 is…

1) First all the above mentioned connectors are downloaded in to catia work bench and are defined electrically. 2) Now new product is created in the assembly design and all the connectors and copied in to this new product      and positioned according to the given figure using compass. 3) Now using Electrical…

 1) In this the P clamp is downloaded in to CATIA work bench, wire entry and exit points with their respective planes are created with base plane as well using part design. Using Electrical part design the the clamp is defined as a support part and necessary provisions defined for wire entry and exit part.  …

1) For the first image of male connector, all the necessary points like Connector connection point, Bundle connection point and axis systems are created in part design and it is defined as connector and later Connector connection point, Bundle connection points are defined using electrical part design workbench. 2) For…