Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge

Route the following harness layout in the Electrical workbench. Make an assumption for harness bundle diameters. Use the following connectors as shown in the layout diagram.

Add protective covering on all branches connected to DT06-2S & DT06-4S connectors. Keep end extremity at 30mm (from connectors end)

Download connector 3D data from www.te.com

• DT06-4S
• DT06-6S
• DT06-2S
• DT06-08SA

Steps Followed to convert mechanical Parts into Electrical parts

Sketch:

Align the Connectors according to the Bundle:

Final Assembly: