Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge

AIM.

Route the following harness layout in Electrical workbench.

CREATION

• Once downloaded the all connector that are open it in part workbench and create the axis system and point that are necessary for define the bundle and connector connection point.
• Then define electrical component using define connector command then establish the bundle connection and connector connection point using the command.
• Then created the product file name it as wiring harness assembly in that create the one more product file name it as assembly geometrical bundle
• In assembly geometrical bundle product file add all the connector file to it after that convert to the electrical harness assembly using geometrical bundle command.
• Create on reference sketch in part work bench then added to the wiring harness assembly.
• By activating wiring harness assembly move the all connector to their position which are mention in reference sketch.
• Then using multi branchable document command route the wiring harness between connector, create the branches using branch point command.
• First open electrical part design workbench and using define protection part command created part by define ID dia, thick and bend radius, after that save the part.
• Next created the catalog document and add family in that selected the conduit then save the catalog file.
• Open the created cot tube then using the sore device command add this part to the catalog then save the file.

After that using protective covering command add the coragat tube to the harness and give the 30mm gap in connector connection point.