Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge
Q1. Route the following harness layout in Electrical workbench. Make assumption for harness bundle diameters. Use Following connectors as shown in layout diagram.
Add protective covering on all branches connected to DT06-2S & DT06-4S connectors. Keep end extremity at 30mm (from connectors end) :-
1. DT06-2S :-
2.DT06-4S :-
3.DT06-6S :-
4.DT06-08SA :-
Creating a path :-
Connection of connector in a path :-
Bundle Connection of the connectors :-
Conclusion :-
- In this week - 4 challenge i had understand that how to define connector geometrical properties also electrical properties.
- By using manipulation & smart move tool of assembly design we can adjust the connector position as we required.
- In Electrical harness assembly the connector is define as multibranchable also create a bundle though it.