Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge

Q1. Route the following harness layout in Electrical workbench. Make assumption for harness bundle diameters. Use Following connectors as shown in layout diagram.

Add protective covering on all branches connected to DT06-2S & DT06-4S connectors. Keep end extremity at 30mm (from connectors end)

Download connector 3D data from www.te.com

• DT06-4S
• DT06-6S
• DT06-2S
• DT06-08SA

• Convecting the Mechanical part into the Electrical part

1. Create/Download connector 3D
2. Create required Geometrical Parameters
3. Define part as Connector
4. Define "Bundle connection point"
5. Define "connector connection point"
6. Define "cavity connection point"

• DT06-2S

• DT06-4S

• DT06-6S

• DT06-08SA

• Creating the harness layout

• Connect All Connectors To Given Path

• Connect all the connectors with bundle and create branch point

• Protective covering on all branches connected to connectors .Keep end extremity at 30mm (from connectors end)