Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge

Q1. Route the following harness layout to the Electrical workbench. Make assumptions for harness bundle diameters. Use the following connectors as shown in the layout diagram.

Add protective covering on all branches connected to DT06-2S & DT06-4S connectors. Keep the end extremity at 30mm (from the connector's end).

Steps to be followed:

1. Download connector 3D data from www.te.com

DT06-4S

DT06-6S

DT06-2S

DT06-08SA

2. connecting the Mechanical part to the Electrical part for which I had followed the following steps.

For DT06-2S

For DT06-4S

For DT06-6S

For DT06-08SA

3. Arranging the Connectors by following the Layout

4. creating Multi-Branching to the connectors

5. Creating a protective covering

6. checking, as per Layout