Wiring harness design in CATIA V5 - 3D modeling Week 2 Challenge

AIM

Convert given part into the electrical connector in electrical part design workbench.

BODY

For connector

Bundle connection creation

• First open part in part design workbench and create center point on face where the bundle connection needed.
• Next switch to electrical part design work bench first define the connector then using the bundle connection point command created the bundle connection point.

Connector connection point

• First open part in part design workbench and create center point then crate the Axis system on that point where y axis is in connecting direction ,x- axis in locking direction ,z axis in upward direction created on the face where the connector connection is needed.
• Next switch to electrical part design work bench first define connector then using the connector connection point command created the connector connection point.

For connector clip

• First open part in part design workbench and create center point then crate the Axis system on that point where y axis is in connecting direction ,x- axis in locking direction ,z axis in upward direction created on the face where the connector connection is needed.
• Next switch to electrical part design work bench using the define cavity command created the cavity connecting point.