Week 9 - Project 1 - Door Applique Design with Engineering Features

Explanation:

1. The given class A surface on top side using extract and offset and create the b surface because we need the solid body.

2. Then Face A and B Join then create a body should be in solid.

3. Then given top face surface create a plane and to do sketch for to create 4 way locator.

4. Check the sketch ensure iso constrained.

5. Then create the 4 way locator via using sketch the pad and then using 0.3 draft angle as per the design rule, then to prevent the sharp edges using champer at 3mm and fillet using 0.5mm as per the design rules.

6. Then using the same in another side via (copy and special paste the main body and put the draft 0.3mm as per the design rules and then using the translate tool adjust the x, y, z. dimension adjust and placed done.

7. Then create the 2 way locator on top side using the same sketch and delete the previous sketch and draw the line and should be iso contrained ensured.

8. Then create a new body and convert into the pad then using draft as per the design rule 0.3mm.

9. Then create the heat stakes parent, using the same sketch and delete the previous drawing and using the circle and ensured isocontrained.

10. Then create the body and pad itselfs and put the draft.

11. This before we create using the point (via- extract the class a surface and take the parallel curve then using the point repetition tool as we how many count we need will placed the point as in extract outer line. Then copy the heat stakes parent body and special paste into the main body then using the translate tool one by one placed in point to point method then heat stake assy as done.

12. Then put the clearance in 4 way and 2 locator and all heat stakes 0.5mm and 0.1 mm clearance

13. Then check the draft analysis