Week 9 - Project 1 - Door Applique Design with Engineering Features

TOOLING AXIS CREATION.

- IN THE GIVEN DOOR APPLIQUE WE CAN SEE WE HAVE A SURFACE NOT MORE COMPLEX.

- I HAVE TAKEN A CENTER POINT ON SURFACE AT 0 CO-ORDINATES.

- FROM THIS POINT DRAW A LINE AT Z DIRECTION.

- WE CAN CONSIDER THIS AS OUR TOOLING AXIS.

- SO I HAVE PERFORM DRAFT ANALYSIS ON THIS.

- AND IT HAS CLEARED FULL SURFACE , SO WE CAN USE THIS AS OUR TOOLING AXIS FOR FURTHER PROCESS.

- NOW I HAVE CREATED B CLASS AND C CLASS SURFACE FOR APPLIQUE AND ALSO 4 WAY AND 2 WAY LOCATORS WITH HEAT STAKES.

- AFTER THAT I HAVE PERFORM DRAFT ANALYSIS ON THIS.

- SOME OF FACES WERE NOT CLEARED BY THIS AXIS.

- SO I HAVE CREATED SIDE CORE AXIS TO CHECK.

- AND ITS BEEN CLEARED SO WE CAN CONSIDER IT AS SIDE CORE AXIS.