Week 9 - Challenge 2 - Switch Bezel Design

AIM:

Create the Switch Bezel Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.

As you can see the area highlighted in red will need to be given a draft , rest of the sections have draft angle greater than 3 degrees.

Creation of Class B surface :

Using surface trim and extract command we get the following :

Creation of Class C surface :

Now we will create sweep surface of the class A surface as shown below

After trimming we get :

We will now trim it of with the class B surface and obtain the following surface as shown below :

Tooling Axis:

Draft Analysis:

how to enter Draft Analysis:

Tooling Direction:

Right View:

Top View:

Front view:

CONCLUSION:

Created sucessfully the Switch Bezel Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.