Week 9 Challenge

respected sir, please check the zip file placed below throughly and if any errors are rien then please send me the error through mail but dont put zero marks to me. it drops my confidence levels. and this solidworks software is completelynew to me

slider-1

• in this challenge i am done with two sliders at respective undercuts presented in solid body
• in order to made it, firstly drag the core part into seperate sketcher and select the nearest face to then click on sketch
• know draw a corner rectangle which covers the entire circular under cut. then went to split commond in direct editing face and click on both sketch and plane that selected to draw
• and then click on cutbodies and select the slider body to remains as same, then go to same plane and get it into sketcher mode and draw the face whichcombines the slider and core and connect them with extrude boss/base commond.
• after that, save the slider body seperately and seperate it with core using suptract tool in combine commond in direct editing bace.
• know come to main assembly part and create a new part file and rename it as slider_1 and import the already saved slider part in to it
• made some clearances to the core body to freely move the slider into core
• then made the same changes to the slider in cavity block also to move free

slider-2

• for slider two also follow the same procedure. to move freely in the core and cavity blocks.